SEM image showing contamination on the surface of a component in an electrical switch assembly. Contamination analysis is conducted to determine the chemical make up and ID of the contaminants to identify the source.
About Atrona Menu
Services Menu
Failure Mode | Root Cause | Case Studies | Procedure SEM/EDS | Microstructure | Material ID | Heat Treat Analysis | Coating Analysis | Grain Flow | Inclusion Ratings | Porosity Analysis | Hardness Testing | Case Depth | Weld Analysis | Salt Spray Reverse Engineering | CMM | Micro Measurements
Services Menu Cont.
Fourier Transform Infrared Spectroscopy - FTIR | Differential Scanning Calorimetry - DSC | Thermogravimetric Analysis - TGA | Melt Flow using Extrusion Plastometer: | Filler Content and filler ID | Mechanical Testing | Hardness Testing | Failure Analysis | Reverse Engineering Magnetic Particle Inspection | Dimensional | Liquid Die Penetrant | Ultrasonic Inspection | Stereoscopic Analysis | Surface Finish Measurements | Other NDT
Services Menu Cont.
Tensile Testing | Torque Testing | Automotive Testing | Environmental Testing | Fatigue Testing - full and half wave | Life Cycle Testing | Durability Testing | Fastener Testing | Consumer Product Testing | Impact Testing | Wear Testing Liability & Litigation | Insurance | Investigations | Law Firms
Engineering Menu
